| Item | Name | Low Voltage Pfr Automatic Power Factor Controller |
| 1 |
LED/LCD Display will show
a.three-phase voltage,current, active power, reactive b.power factor and power network frequency, control parameter |
|
| 2 | Strong anti-interference ability can resist 2kv impulse test ,keep data | |
| 3 | You can revise control data sheet ,it will save data no power | |
| 4 | Auto analysis phase function | |
| 5 | Current get signal resistor less than 0.05Ω | |
| 6 | Over voltage ,under voltage lack phase protection function | |
| 7 | Input way: static ,Dynamic ,compound | |
| 8 | Rated voltage | AC 220V±10% AC 380V±10% |
| 9 | Rated current | AC 0-5A |
| 10 | Rated frequency | 50Hz±5% |
| 11 | Sensitivity | 100mA |
| 12 | COS φ Preset | 0.80-0.99; step length 0.01; Factory preset 0.98 input and cutoff time |
| 13 | Input Delay |
dynamic state 100ms-30S; Static state 1-250S;Factory preset dynamic state 5S;
static state 30S. |
| 14 | Over-voltage protection | 230-260V; step length 1V; Return difference 6V reset 240V, |
| 15 | Under-voltage protection | 180V;return difference 6V |
| 16 | Auto Discriminating Phase | ON/OFF; factory preset ON(Auto discriminating ON) |
| 17 | Reactive threshold | OFF-4-100kvar; factory preset OFF (reactive threshold inefficiency) |
| 18 | CT variation | 50/5A-3000/5A; step length 1; factory preset 500/5A |
| 19 | Capacitance capacity | 0-99kvar factor preset of each branch 10kvar |
| 20 | Contact capacity |
dynamic state output of each branch DC12V×50mA
Static state output of each branch 380V×7A/200V×5A |
| 21 | size | 113*113 138*138 |